Outlive the Outbreak Banner-01

Your First Hydroponic Plant (Beginner’s Guide)

By on December 4, 2013

1743313_10201925946363310_1522188705_n

Start your very first miniature hydroponic plant! A recommended guide for beginners who both loves planting and technology. I’m going to show you how to make one in less than 15 minutes, out of household materials! Our tiny “Hydroponic System” kinda cost us $5-7.

Recommended Seeds/ Plants:
– Tomato Seeds/ Plant
– Mung Beans/ Plant (We used this one)
– Chili Pepper

Step 1: Gathering Your Tools And Materials

Parts & Materials: (Some links are just alternative, I bought mine for $5)

– Recycled Container (Free)
– Controlled Fertilizer ($1.00)
– 
DC Water Pump ($4.00)
– 
A Cheap Mini Funnel ($0.10)
– 
Aquarium Tubing ($0.40)
– 
Water Flow Valve ($0.20)
– T-Shaped Splitter ($0.10)
– Super Glue/ Epoxy ($1.00)

Recommended Pump Kit: DIY Water Pump Motor Water Pipe Power Supply Set ($12.90)

Tools & Equipment:
– Leatherman Multitool (Gift From: Instructables)
– Rotary Tool (Dremel/ Black & Decker)
– Permanent Marker
– Soldering Iron
– Hot Glue Gun
– 12inch Ruler

step1 ste1 st1

Step 2: Installing The Water Distribution System In Your Funnel

step2 ste2 st2 s2

Our hydroponic setup uses a simple water drip system. Water needs to reach the plant, also needs to get distributed evenly.

1st.)  Drill a hole on your funnels side for the T-splitter.
2nd.) Measure the inner circumference of your funnel and cut a strip of tube [Formula: (2)(π)(r)]
3rd.)  Slit some hole on your tube using a knife, be sure to slit it on 5 even sides. Use a ruler!
4th.)  Connect your tube on the T-shapped splitter
5th.)  Apply a few drops of super glue to mount your assembled drip system (tube) on your funnel

Step 3: Glue The Assembled Funnel To The Cover

step3 ste3 st3

This is a three step procedure, be careful in handling knives and hot-glue.

1st.)  Trace your funnel on top of your container’s cover
2nd.) Use your leatherman’s knife  to cut a hole cleanly
3rd.)  It’s now time to warm up your gluegun and mount the funnel to your container’s cover. Be sure to seal in the gaps!

Step 4: Installing Your Water Pump

step4 ste4 st4

There are some factors to consider in buying water pumps, the AC (outlet type) consumes a lot electricity and isn’t compatible with solar panels, the DC (battery type) can be easily hooked to a solar panel w/battery, providing free electricity 24/7.

Okay lets get started! What I have here is a non-submersible water pump, which I found from my inventory. I had to drill a hole on the container in order to add a pinch valve (water flow valve). The pump is slightly elevated since it is not water proof. 

Step 5: Finalizing The Setup

step5 ste5 st5

I saw this pack of fertilizer lying around my our garden, it was my dad’s. It’s a typical complete & controlled fertilizer for general purpose. For my setup, I just dropped 2 table spoons of fertilizer. If your concerned for your plant’s nutrition, there are some fertilizers designed for hydroponic setups found in Amazon.com

Use smooth pebbles to hold your plant’s roots, make sure they are tucked in firmly.

Step 6: Soil Planting Vs. Hydroponics

step6 ste6

Here are our the results of our experimentation for our investigatory project in school. You can find a significant difference between the comparison of the soil planted plant and the hydroponic plant. The hydroponic plant started as the underdog, time passed it managed to surpass the growth of the soil planted plant.

Bottom Line: Plants planted on a hydroponic medium, grows faster = Hydroponic Wins!

By Ascas

1743313_10201925946363310_1522188705_n

About The Survivalist

Total bacon buff. Explorer. Survivalist Expert. Zombie Fanatic/Hunter. Internet Entrepreneur

2 Comments

  1. Pingback: Your First Hydroponic Plant (Beginner’s Guide) | The DayOne Gear Blog

  2. Pingback: Your First Hydroponic Plant (Beginner’s Guide)

Leave a Reply

Your email address will not be published. Required fields are marked *