Democrats Pushing Bill targeting AR15 BUILDS!

• Tweet
• Pin It

The ban is going after parts kits and 80% LOWERS and seems to target AR15 builds in general.

What is H.R. 7115? You can find the full text here:

To prohibit the sale, acquisition, distribution in commerce, or import into the United States of certain firearm receiver castings or blanks, assault weapon parts kits, and machinegun parts kits and the marketing or advertising of such castings or blanks and kits on any medium of electronic communications, to require homemade firearms to have serial numbers, and for other purposes.

Pay close attention to Section 3:

SEC. 3. Prohibition of advertising do-it-yourself assault weapons.

(a) In general.—It shall be unlawful to market or advertise, on any medium of electronic communications, including over the Internet, for the sale of any of the following:

(1) A firearm receiver casting or firearm receiver blank or unfinished handgun frame that—

(A) at the point of sale does not meet the definition of a firearm in section 921(a) of title 18, United States Code; and

(B) after purchase by a consumer, can be completed by the consumer to the point at which such casting or blank functions as a firearm frame or receiver for a semiautomatic assault weapon or machinegun or the frame of a handgun.

(2) An assault weapon parts kit.

(3) A machinegun parts kit.

H.R. 7115 was introduced on November 2, 2018 and sponsored by Rep. Frank Pallone, Jr., a Democrat from New Jersey for “himself, Mr. Sires, Ms. Norton, Mr. Cárdenas, Mr. Khanna, Mr. Pascrell, Ms. Schakowsky, Mr. Hastings, Ms. Clarke of New York, Mr. Carbajal, Mr. Soto, Mr. McGovern, Ms. Kelly of Illinois, and Mr. Rush).” It has been referred to the Committee on Energy and Commerce and the Committee on the Judiciary.

Breitbart Writes Democrats in the House quietly put forward a ban on 80 percent frames and gun parts kits while Americans were focused on voting and watching the outcome of the midterm elections.
The legislation, HR 7115, is sponsored by Rep. Frank Pallone (D-NJ) and has 16 Democrats as co-sponsors.

The state’s purpose of “the legislation is to prevent the sale, possession, or advertising, of 80 percent receivers, gun parts kits, etc.

The text of HR 7115 says:

To prohibit the sale, acquisition, distribution in commerce, or import into the United States of certain firearm receiver castings or blanks, assault weapon parts kits, and machine gun parts kits and the marketing or advertising of such castings or blanks and kits on any medium of electronic communications, to require homemade firearms to have serial numbers, and for other purposes.

The Firearms Policy Coalition warns that the bill is ambiguous and would be far-reaching. For example, they explain that HR 7115 does not “make a distinction between upper and lower receivers” for AR-15s and would make “home gunsmithing” illegal.

Ironically, firearms built from 80 percent lowers are not 3-D firearms, yet the legislation is ubiquitously titled, “3-D Firearms Prohibition Act.”

• Tweet
• Pin It

Related Posts

• 

  Do Water Purifiers Remove Fluoride?
  Do Water Purifiers Remove Fluoride?
• 

  Survival Fishing Gear
  Survival Fishing Gear
• 

  Stop Summer Garden Beetles Without Using Chemicals
  Stop Summer Garden Beetles Without Using Chemicals
• 

  Illinois: Bill Introduced to Ban Many Firearms & Accessories
  Illinois: Bill Introduced to Ban Many Firearms & Accessories