Outlive the Outbreak Banner-01

.223 Survival Whistle

By on July 9, 2013

1743313_10201925946363310_1522188705_n

Because yelling will make you lose your voice, it’s important to carry a whistle just incase you get in a jam. 

Before you start, clean out the brass with dish soap and cotton swabs. Clean inside and out until the swabs come out completely white.

Grip the shell in a clamp. Make sure to clamp the primer side of the shell or it will collapse. Also if you don’t have a wooded clamp you can improvise to protect from scratching up the brass with something like an old leather belt.

Using a ¼” triangle file, file a notch ¼” down from the taper line on the shell. Make sure to keep the leading edge of the file at 90 degrees. See the pictures. Keep filing until the trail edge of the file is flush with the shell wall.

Remove any burs.

2 

Use a pair of diagonal cutting pliers to remove the primer side of the .22 shell. Next take a scrap piece of brass from another shell and solder it halfway onto the business side of shell. See the pictures.

Use metal shears to cut off the excess. Smooth out any rough edges with a hobby file.

3 4

Insert the half covered side of the .22 shell into the opening of the .223 shell. For best results you have to make two things sure. 

5

One: the end of the .22 shell lines up with the notch cut in the shell.
Two: the opening of the .22 shell is parallel to the notch cut out in the .223 shell.

Solder the .22 shell in place. Be careful not to over do the heat or you might melt the solder away from the half cover.
6

File the blowing end flush with a hobby file. Next use a polishing wheel with polishing compound to buff the whistle to a shine.

By Mrballeng

1743313_10201925946363310_1522188705_n

About The Survivalist

Total bacon buff. Explorer. Survivalist Expert. Zombie Fanatic/Hunter. Internet Entrepreneur

Leave a Reply

Your email address will not be published. Required fields are marked *